accessories

Product Name

Price

1 Inch Wide Hinge Tape (Blenderm)

$2.99

0.5 Inch Wide Hinge Tape (Blenderm)

$1.99

Battery Monitor 2-6S

$4.99

Turnigy Voltage Booster for Servo & Receiver Out of Stock

$4.99

Signal loss Alarm & Lost Plane Finder Out of Stock

$6.99

1-8s Lipo Volt Checker & Low Volt Buzzer

$6.99

1 inch wide hinge tape (blenderm)

• Strong adhesion
• Best choice of hinge tape for Depron aircraft
• 1 in x 5 yds

0.5 inch wide hinge tape (blenderm)

• Strong adhesion
• Best choice of hinge tape for Depron aircraft
• 0.5 in x 5 yds

Battery Monitor 2-6S

Simple & easy to use! A perfect solution for when youre at the field and not sure if your battery is charged! The BMON6 plugs into your battery balance plug and will quickly tell you the total voltage as well as each cells individual voltage.

Important:
This item is not accurate enough for precise cell balance checking. It is to be used to check battery charge status.

Turnigy Voltage Booster for Servo & Receiver
recommended for nanofalcon

Specifications:
Operating Voltage : 3.2V - 4.2V
Operating Current : 1A
Max operating Current : 1.5A
Weight: 2.9g

Lipoly Single cell voltage booster for Receivers and servos. This little unit plugs into your single cell lipoly and will boost the voltage to 5V, allowing you to run a receiver on a single cell lipo. This little voltage booster weighs just 2.9g with wire and plug and full length pins. It is built on a flexible PCB (the same type used in your mobile phone to control the screen) so its very light and thin.

Warning! Pay attention to the polarity of plugs and never use more than one single lipo cell to power the voltage booster.

Signal loss Alarm & Lost Plane Finder

Signal loss Alarm & Lost Plane Finder, simple device that plugs into any servo/rx port, will detect the loss of TX signal and emit a loud 85dB alarm. Ideal for warning you if you have not turned off your RX power supply while in the pits, or if you are having trouble finding a model in the long grass, simply turn off your TX and within a minute, the alarm will sound!

Specifications:
Weight: 4.5g
Operating Voltage: 4v~6v
Current Drain: 1~35mAh

1-8s Lipo Volt Checker & Low Volt Buzzer 2-IN-1 UNIT

Plug this into your balance connector and use this to check your lipo voltage. It reads individual cell voltages and then total cell voltage. Leave it on your plane and it will monitor your voltage in flight and when it reaches the set voltage (programmable) then it will produce a Loud buzzing alarm which can be heard from distance.

This is great way to bring your plane in before low voltage cut off on your ESC results in a dead stick landing or not enough power to reach the landing area.

Specifications:
Unit voltage display range 0.5-4.5V
Total voltage display range: 0.5 - 36V
Use for 1-8S Lipo/LiMn/Li-Fe
Voltage detection precision ±0.01V
Unit voltage display range 0.5-4.5V
Total voltage display range: 0.5 - 36V
1S test mode voltage range: 3.7-30V
Low voltage alarm mode for 2-8S
Alarm set value range: OFF-2.7-3.8V
Weight: 8.7g/ 0.31oz